Stainless 1/4"mfl nut to 3/8 barb

Purchase Stainless 1/4"mfl nut to 3/8 barb

Other products in the category Beer Brewing / Kegging Equipment:

• Complete Keg System -- Used 5 Gallon Canister

• Complete 5 Gallon O-Ring Set -- Use to Referbish 5 Gallion Cornelius Kegs

• Kegerator Conversion Kit -- Converts your fridge into a draft beer dispenser

• C02 cylinder 10 pound new -- Fits 10 Pounds of C02

• CO2 cylinder five pound new -- ALUMINUM

• Air shut off valve w/ backflow preventer -- TO BE MOUNTED ON THE BOTTOM OF A REGULATOR.

• Double gauge regulator -- Recommended for CO2 tanks 10 pounds and more.

• High Pressure Gauge

• Low pressure gauge

• Plastic CO2 washer

• Single gauge regulator

• Used 5 Gallon Soda Canister (ball lock) -- Reconditioned

• Ball valve o-ring -- Medium size O-ring. Two are visable on outside of ball-lock kegs.

• Ball-Lock Poppet Valve -- For Cornelius Kegs

• Diffuser Stone -- Stainless Steel

• Dip tube gas (stainless) -- for soda kegs

• Dip tube o-ring -- For use with 5 gallon soda kegs.

• Stainless hose clamps 1/4" to 3/8"

• Universal beer hex nut

• Universal beer nut washer

• Wooden bungs for half barrels

• Disconnect - Ball lock with 1/4" barb (Fluid) -- for soda keg

• Disconnect - Ball lock with 1/4" barb (gas) -- for soda keg

• Disconnect - Ball Lock with 1/4" flare(fluid) -- for soda keg

• Disconnect - Ball Lock with 1/4" flare(gas) -- for soda keg

• Disconnect - Pin Lock with 1/4" barb (Fluid) -- for soda keg

• Disconnect - Pin lock with 1/4" barb(gas) -- for soda keg

• Disconnect - Pin Lock with 1/4" flare(fluid) -- for soda keg

• Disconnect - Pin Lock with 1/4" flare(gas) -- for soda keg

• Old Firestone poppet valve

• Pin valve o-ring

• Pin-Lock style Poppet Valve

• Relief valve assembly for canister lid

• Top closure o-ring

• Barbed reducer 3/8" to 1/4" Stainless -- Stainless Steel

• Hose thread to 3/8" barbed tail-piece

• Plastic tee 1/4" barb

• Plastic tee 3/8" barb

• Stainless 1/4"mfl nut to 1/4 barb

• Stainless cross-1/4" barb

• Stainless tee- 1/4" barb

• B-valve counterpressurebottlefiller

• Carbonator cap to force carb PET bottler

• 5" Shank with Beer Nut / Washer and Barbed Tailpiece -- MUST SPECIFY SIZE OF BARBED TAIL PIECE (5/16, 1/4, 3/8 or 1/2)

• Chrome faucet and black nob

• Combo shank and faucet -- Must specify size of barbed tail-piece (5/16,1/4,3/8 or 1/2)

• Drip tray stainless steel -- No Drain

• Faucet brush

• Faucet o-ring

• Faucet wrench